Advertisement
Figure 8
2. Capacitance measurement
1) Turn on the power.
2) If exists voltage in the capacity, connect the two ends of the capacitor for a short time to discharge.
3) There are two ways for capacitance input:
a. Insert the positive polarity of capacitance into the positive terminal and its negative polarity into the negative terminal
(shown in figure 10);
b. Insert the black and red testing lines with alligator clip into the "L
respectively. Connect the alligator clips to the two ends of capacitance corresponding to its polarity (shown in figure 11).
4）The default test mode is Auto LCR mode, the capacitance value will show on primary display and the dissipation factor D
will show on secondary display. In Auto LCR mode, the D/Q/ESR key, SEL/PAL key, SORTING key and REL% key
20
Figure 9
", "L
CUR
" terminal and "H
POT
CUR
АМM-3320
", "H
" terminal
POT
Advertisement
