Hewlett Packard Enterprise recommends installing the screws on the board before inserting the
module into the board.
5. Connect the two antenna cables to the antenna connectors on the half-length WiFi module.
6. Install the bottom access panel.
7. Install the antenna on page 9.
8. Mount the gateway on page 10.
9. Power up the gateway on page 9.
Installing the full-length WiFi/WLAN module
Procedure
1. Power down the gateway on page 9.
2. Dismount the gateway on page 12.
3. Remove the bottom access panel on page 15.
26
Installing the full-length WiFi/WLAN module