Removing And Replacing A Full-Length Wifi/Wlan Module - HPE GL20 Maintenance And Service Manual

5. Using a T-10 Torx screwdriver, remove the two screws securing the half-length WiFi module to the
gateway.
6. Remove the half-length WiFi module and adapter assembly.
To replace the component, reverse the removal procedure.
Press the Power On/Off button twice to power on the gateway.

Removing and replacing a full-length WiFi/WLAN module

Procedure
1. Power down the gateway (Powering down the gateway on page 19).
2. Dismount the gateway (Dismounting the gateway on page 19).
CAUTION:
DO NOT remove the top access panel under any circumstance. Removing the top access panel
can harm the heatsink or void the warranty to the equipment.
24 Removing and replacing a full-length WiFi/WLAN module