Configuration; Jumper Settings; Setting The Jumpers - HPE GL10 User Manual

Configuration

Jumper settings

Jumpers are used to close electric circuits. You can configure cards by setting the jumpers in the system.

Setting the jumpers

Prerequisites
Before setting the jumper or clearing CMOS, you must turn off the power supply to avoid damaging the
computer. Before powering on the power supply, you must ensure that the CMOS jumper is back to 3.0
V Battery On.
You will need a standard cable to make the connections.
For more information about the best hardware configuration for your gateway, contact an authorized
reseller or an authorized service provider.
Procedure
1. Power down the gateway on page 9.
2. Dismount the gateway on page 12.
3. Remove the bottom access panel on page 15.
4. Locate the jumper.
Item
1
2
3
5. Set the jumpers by installing the jumper clip on the pins. Jumpers can be set to the following modes in
this system:
28 Configuration
3
2
1
Pin number
1
2
3