Hardware Options Installation; Installing The 3G Module - HPE GL10 User Manual

Hardware options installation

Installing the 3G module

Only one (half-length or full-length) module can be installed at a time.
Prerequisites
• Use only HPE approved 3G modules. Non HPE approved modules might not be compatible with the
system. For more information on HPE approved modules, see the product QuickSpecs on the Hewlett
Packard Enterprise website (http://www.hpe.com/info/qs).
• The 3G module option will work only if a SIM card is installed in the system. Be sure to purchase a
SIM card while purchasing a 3G module.
Procedure
1. Power down the gateway on page 9.
2. Dismount the gateway on page 12.
3. Remove the bottom access panel on page 15.
4. Install the SIM card.
5. Using a T-10 Torx screwdriver, install the 3G module using at least one screw to secure the module.
Hewlett Packard Enterprise recommends installing the screws on the board before inserting the
module into the board.
6. Connect the two antenna cables to the antenna connectors on the 3G module.
24 Hardware options installation