Hardware Options Installation; Installing The 3G/Lte Module - HPE Edgeline EL20 User Manual

Hardware options installation

Installing the 3G/LTE module

Procedure
1. Power down the gateway on page 10.
2. Dismount the gateway on page 12.
CAUTION:
DO NOT remove the top access panel under any circumstance. Removing the top access panel
can harm the heatsink or void the warranty to the equipment.
3. Remove the bottom access panel on page 13.
NOTE:
The 3G/LTE module can be installed in either of the two PCI slots. If there is only one 3G/LTE
module installed, Hewlett Packard Enterprise recommends installing in the slot on the right.
NOTE:
If you are installing a module that requires USB routing, install the module in the full-height PCIe
slot. The half-height PCIe slot on the system board does not support USB signal.
4. Using a T-10 Torx screwdriver, install the module with the two screws.
5. Connect the two WAN antenna cables to the antenna connectors on the 3G/LTE module.
Hardware options installation 23