Gpib Interface; Communication Protocol - ITech IT6121B User Manual


Device is RL1 enabled.

Device is DT1 enabled

5.3 GPIB interface

First, Connect the GPIB interface on the power supply and the GPIB card on
computer via IEEE488 bus, must be full access and tighten the screws. Then set
the address, the address range of the power : 0 to 30, can set by the function key
on the front panel, press the
function, find the GPIB address setting by
Enter Enter

5.4 Communication protocol

IT6100B programming should adopt SCPI communication protocol, please contact
ITECH to get the protocol you need.
key to confirm. GPIB address is stored in nonvolatile memory line
Copyright © ITECH Electronics Co., Ltd.
I-set I-set
(Shift)+ key to enter the system menu
button, type the address,
Remote Operation Mode
37