Table of Contents
Advertisement
Polycom RMX 4000 Hardware Guide
DC Power Rail Module
Component Slot Allocation
A DC power rail module includes a power inlet, circuit breaker, EMI filter
and backplane connectors. Power input to the system is fed via a power
rail through backplane into the power supply. Each DC power rail has its
own dedicated power cable. The circuit switch on the rear of the RMX
activates independently any power rail installed on the RMX. An DC
system has two DC rails, one for each power rail. On failure, a DC power
rail is field replaceable and the RMX must be switched OFF from the two
circuit switches and the mains.
On the RMX™ 4000, components have been assigned dedicated slots as
defined in Table 1-11. Slot numbers are located on both the front and rear
of the RMX™ 4000.
Table 1-11
RMX™ 4000 Slot Numbering
Slot ID/No.
Card/Component
1-4
MPM+/MPMx
Cards
5
Fabric Switch
Module (FSM
4000)
6
CPU 2
7
Logo Panel
8
CTNL 4000 unit
(CPU 1)
9-11
AC Power Supply
Requirement
Mandatory: At least 1 MPM+/MPMxcard
is required. Each media card also
requires either an RTM ISDN or an RTM
LAN card.
Mandatory
Not Available (NA)
Not Available (NA)
Mandatory
An RMX with AC power has 3 power
supplies installed. A 3rd power supply is
redundant (n+1).
Note: Not used with DC powered
systems. DC powered systems receive
Direct Current from the power rail .
1-31
Advertisement
Table of Contents
