Installation Procedures; Installing Network Interface Modules; Quad Bri Network Interface Module; Figure 4-2. Installing Network Interface Modules - Polycom SoundStation2 EX, FX, VS4000 Integrator's Reference Manual

Installation Procedures

Installing Network Interface Modules

ViewStation EX,
ViewStation FX,
or VS4000

Quad BRI Network Interface Module

© Polycom, Inc.
For basic system installation, please refer to the installation
instructions in the appropriate User Guide and the QuickStart cards.
The ViewStation EX, ViewStation FX, and VS4000 may be
purchased with either of these network interface modules:
Quad BRI
V.35/RS-449/RS-530
In addition, PRI T1 and E1 network interface modules are available
with the ViewStation FX and VS4000.
The diagram below shows a general view of how network interface
modules are installed.
Network
interface
module
External power
supply
(if using PRI)

Figure 4-2. Installing Network Interface Modules

This section provides information about installing the Quad BRI
network interface module. For performance specifications, cable
diagrams and pinouts, and other technical information, please refer
to Technical Information, on page
Chapter 4 - Installing Videoconferencing Systems
Auxiliary device
(such as NT-1 if
using Quad BRI,
CSU if using PRI)
UPS
11.
ISDN
network
Power
source
79