Troubleshooting - Siemens HB 760.60 B Instruction Manual

Troubleshooting

Problem
The oven does not work.
The clock display flashes.
The oven door cannot be
opened. The function selector
is in the * position and three
zeros are flashing in the
display.
The oven does not heat up.
The oven does not heat up or
the type of heating selected
cannot be set.
The oven does not heat up. A
square appears in the
temperature display.
A 5" appears in the clock
display.
The Er 1" or Er 4" error
message appears in the clock
display.
The Er 2" error message
appears in the clock display.
The Er 6" error message
appears in the clock display.
You have set self cleaning.
44
Should a malfunction occur, it is often only due to a
minor fault. Please read the following instructions
before calling the after sales service:
Possible cause
Blown fuse
Power cut
Power cut
The oven door is not
properly closed.
Dust on the contacts.
The appliance is currently
in demo mode.
The automatic time limiter
was activated.
The temperature sensor
has failed.
Incorrect mains connection
The lock on the oven door
is defective.
Comments/remedy
Look in the fuse box and check that the
fuse is in working order.
Reset the time.
Switch off the function selector. Set the
time of day and restart self cleaning.
If you no longer wish to repeat
automatic self cleaning, you must still
wait for the oven temperature to fall
below 300 ºC.
Close the oven door fully.
Turn the function selectors round
completely several times.
Switch off the fuse in the fuse box. Wait
for approximately 20 seconds. Switch
on the fuse again. Within the next
2 minutes, press the rapid heating up
button for 6 seconds until the square in
the display disappears.
Switch off the function selector.
Contact the after sales service.
Remove the fuses from the fuse box and
connect the cooker properly.
Remove the fuse from the function
selector and call the after sales service.
All other oven functions can be used.