Table of Contents
Advertisement
en Troubleshooting
Remove the pull-out rail.
4.
Clean the pull-out rail.
5.
→ "Cleaning products", Page 22
Note:
Further information:
22.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
Guide the pull-out rail with the rear retainer
below behind the two guide rods for the required
shelf position and keep it horizontal.
Troubleshooting
23 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
30
Guide the rail lengthways to the rear to the guide
2.
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer
tical rod.
Press and hold PUSH
3.
inwards
lower rod.
from
Release the PUSH tab.
4.
a The retainer clicks into place.
Pull the pull-out rail out as far as it will go and slide
5.
it back in.
Note:
Further information:
and swing the pull-out rail
until the retainer
is attached in the
a
to grip the ver-
Advertisement
Table of Contents
