Replacing A Fan Tray For An Hsr6808 Router; Replacing An Air Filter - HP FlexNetwork HSR6802 Installation Manual

Figure 54 Pulling out the fan tray
4. Holding the handle of the fan tray with one hand and supporting the bottom of the fan tray with
the other hand, gently push the fan tray into the slot along the slide rails until it is completely
seated.
5. Use a Phillips screwdriver to fasten the captive screws on the fan tray.

Replacing a fan tray for an HSR6808 router

1. Face the front of the router.
2. Press the fan tray release button with the thumb, slightly pull the fan tray away from the chassis,
and slowly pull the fan tray out along the slide rails when fans stop spinning.
3. Holding the front part of the fan tray with one hand, pressing down the release button with the
thumb, and supporting the bottom of the fan tray with the other hand, push the fan tray into the
slot along the slide rails until the fan tray makes complete contact with the backplane.
Figure 55 Pulling out the fan tray

Replacing an air filter

IMPORTANT:
You can clean the air filter with water, but wait until it is completely dry before installing it again.
47