Switching Between Full-Screen Video And The Home Screen; Enabling Dual Monitor Emulation - Polycom 9.0.6 Getting Started Manual

Switching Between Full-Screen Video and the Home Screen

Enabling Dual Monitor Emulation

© Polycom, Inc.
4. Press and hold a number to store the preset position. To store a
double-digit preset, press the first digit quickly and hold the second
number down. Any existing preset stored at the number you enter is
replaced.
The system uses preset 0 as the default camera position.
To delete all presets:
1. If a call is connected, press
2. Press Preset on the remote control.
3. Press Delete to delete all presets.
You cannot delete just one preset. Instead, override an existing preset with the new
camera position.
When the call connects, the system automatically shows the video on the
whole screen. You can switch back to the home screen during a call if, for
example, you need to adjust a user setting, and your system is configured to
allow you to do so.
To see the video in the full screen:
 Press Near on the remote control.
To see the home screen:
 Press Home on the remote control.
Depending on your system configuration, you may be able to set your system
for Dual Monitor Emulation (also called split-screen viewing). With Dual
Monitor Emulation, you can see both the near and far sites on one monitor.
To enable Dual Monitor Emulation:
1. Select System from the Place a Call screen.
2. Select User Settings from the System screen.
3. Select Next to see more settings.
Getting Started Guide for the VSX Series
Near to choose a near-site video source.
11