Table of Contents
Advertisement
CONFIGURATION SETPOINTS
LED indicators
4–12
These setpoints allow the user to control the display characteristics of the front panel
LEDs.
The following setpoints are available.
User 1 LED Assignment, User 2 LED Assignment, User 3 LED Assignment
Range: Any alarm trip control I/O operand
Default: Not Set
Set to program the GCP/BCP user LEDs to follow an internal element.
USER 1 LED Color
Range: None, Red, Green, Orange
Default: Red
Selects the color of the USER LEDs.
USER 2 LED Color
Range: None, Red, Green, Orange
Default: Red
Selects the color of the USER LEDs.
Reset Lockout using Reset Key
Range: Disabled, Enabled
Default: Disabled
If set to "enabled," the GCP/BCP reset key will perform a non-lockout and lockout reset.
Change Mode when Running
Range: Disabled, Enabled
Default: Disabled
When this setpoint is programmed as "Disabled," the relay does not allow changing of
the Auto/Manual mode. When programmed as "Enabled," the relay does allow changing
of the Auto/Manual mode.
Running LED Color
Range: None, Red, Green, Orange
Default: Green
Selects the color of the Running LED.
Stopped LED Color
Range: None, Red, Green, Orange
Default: Red
Selects the color of the Stopped LED.
Alarm LED Color
Range: None, Red, Green, Orange
Default: Orange
Selects the color of the Alarm LED.
Tripped LED Color
Range: None, Red, Green, Orange
Default: Red
Selects the color of the Tripped LED.
Comms OK LED Color
Range: None, Red, Green, Orange
Default: Green
Selects the color of the Comms OK LED.
MM200 MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: SETPOINTS
Advertisement
Table of Contents
