5.2
Removal of an input board
W
ARNING
C
AUTION
charge (ESD) sensitive parts.
The procedure below is applicable to all the input modules of the Input & Communication Unit of the projector.
How to remove
1. Switch off the projector and unplug the power cord at the projector back side.
2. Release the 3 captive screws of the input module (4).
4
Image 5-2
3. Pull out the input module of the Input & Communication using the handles.
R5906113 UDX 07/07/2017
:
The procedures below may only be performed by Barco trained and qualified technicians.
:
Always wear a wrist band which is connected to the ground while handling the electrostatic dis-
4
4
5. Input & Communication
51