Installation Of The Gsm Module - Barco UDX 4K22 Installation Manual

5.7

Installation of the GSM module

W
ARNING
C
AUTION
charge (ESD) sensitive parts.
Necessary tools
PH1 Phillips screwdriver
Necessary parts
SIM card (not delivered)
How to install
1. Remove the Communication board.
2. Remove the drive fastener (1) from the front side of the Communication module.
Image 5-16
3. Slide in the SIM card into the SIM card holder (2).
Ensure that the truncated corner of the SIM card is facing the edge of the module (3).
Image 5-17
4. Plug in the antenna wire connector on the front side of the GSM module (4).
R5906113 UDX 07/07/2017
:
The procedures below may only be performed by Barco trained and qualified technicians.
:
Always wear a wrist band which is connected to the ground while handling the electrostatic dis-
1
2
5. Input & Communication
3
67