Remote Control, Battery Installation - Barco UDX 4K22 Installation Manual

3. Physical Installation
3.1

Remote control, Battery installation

Where to find the batteries for the remote control ?
The batteries are not placed in the remote control unit to avoid control operation in its package, resulting in a shorter battery life
time. At delivery the batteries can be found in a separated bag attached to the remote control unit. Before using your remote control,
install the batteries first.
How to install
1. Push the battery cover tab with the fingernail a little backwards (1) and pull, at the same time, the cover upwards (2).
Image 3-1
2. Insert the two AA size batteries, making sure the polarities match the + and - marks inside the battery compartment.
Tip: Use alkaline batteries for optimum range and life time.
Image 3-2
3. Insert (1) both lower tabs of the battery cover in the gaps at the bottom of the remote control, and press (2) the cover until it clicks
in place.
2
Image 3-3
When replacing batteries, the broadcast address of the RCU will be reset to its default value '0'.
C
AUTION
battery is replaced with an incorrect type.
30
1
1
:
Replace with the correct battery type. Use two AA size batteries. There is a risk of explosion if the
2
R5906113 UDX 07/07/2017