How To Install - Barco UDX 4K22 Installation Manual

5. Input & Communication
Necessary tools
PH1 Phillips screwdriver

How to install

1. Remove the Communication board.
2. Remove the drive fastener (D) from the front side of the Communication module.
Image 5-9
3. Plug in the antenna wire connector on the WIFI module. Ensure to use bottom connection.
Image 5-10
4. Place the WiFi module (2) upon the plastic socket (1). Note that the plastic socket is provided with two positioning pins which fits
the small holes of the WiFi module.
5. Press the plastic cover (3) upon the plastic socket containing the WIFI module as illustrated.
3
2
1
Image 5-11
6. Install the WiFi assembly on the Communication board as illustrated. Use four screws (4) and 4 nuts (5) to secure the WiFi
assembly.
64
D
R5906113 UDX 07/07/2017