Starting Image Projection - Barco UDX 4K22 Installation Manual

• Device serial number and article number
• Current firmware version and model name
• Current illumination (in percentage)
• Projector runtime in hours
• Uptime in hours
• Chosen source
• Current resolution and refresh rate
• Chosen communication method and IP address (if connected)
• Active functions

Starting image projection

1. Make sure the available sources are connected to the appropriate input ports.
Tip: If properly connected, the "SYNC" LED will lit up ORANGE.
2. Press the Input Selection button on the keypad or on the remote control until:
- the LED of the selected source (the "SEL" LED) lit up GREEN, and
- the image of the selected source is projected.
1
Image 6-3
R5906113 UDX 07/07/2017
2
6. Getting Started
73