SHOWTEC Data Flash Strobe Manual page 18

Data Flash Strobe
you can select one of the 4 dimming curves, by pressing the UP/DOWN buttons.
05) In menu
06) With the menu
choose Smooth or Fast.
07) In the menu
08) Press the UP/DOWN buttons to choose between 10, 20, 30 or 60 seconds. If you choose the option
"ON", the display will remain continuously ON, when no button is pressed.
09) The last option
10) Press the SETUP button to open the menu and then press the UP/DOWN buttons to choose Yes or No.
11) Press the SETUP button again to confirm your choice. If you have chosen Yes, the factory settings will
be restored.
12) In the menu
13) Press the SETUP button to open the menu and then press the UP/DOWN buttons to choose Off or
Hold. If you have chosen Off, the device will black out. If you have chosen Hold, the device will use
the last properly received DMX signal until DMX connection is restored.
14) Press the SETUP button to confirm your choice.
15) In the menu
16) Press the SETUP button to open the menu and then press the UP/DOWN buttons to choose On or Off.
17) Press the SETUP button to confirm your choice.
Ordercode: 40296
, you can set the dimmer speed, by pressing the UP/DOWN buttons. You can
you can set how long the display will remain ON, when no button is pressed.
is for resetting the device to the factory settings.
you can set the device's behavior in case of a DMX signal error.
you can set synchronous DMX.
17