Table of Contents
Advertisement
Data Flash Strobe
Main Menu Options
On start-up, the device will show the current software version:
1. Auto Run Mode
With this menu you can start Auto Run mode.
01) Press the MODE button and then the UP/DOWN buttons, until the display shows
02) The Data Flash Strobe will now run all the built-in programs in a sequence.
2. Built-in Programs
With this menu you can you can set the built-in programs.
01) Press the MODE button and then the UP/DOWN buttons, until the display shows
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to toggle through the 25 built-in programs.
04) Once you have selected one of the programs
open the program.
05) Press the SETUP button several times to toggle between strobe frequency and program speed
settings.
06) Press the UP/DOWN buttons to change the values.
3. Slave Mode
With this menu you can set the device as a slave.
01) Press the MODE button and then the UP/DOWN buttons, until the display shows
02) If the device has not been set to slave, it is automatically classified as a master device. All slave
devices will follow the master. If the device has been set to slave, it will react the same as its master
device.
Ordercode: 40296
1. Auto run
2. Built in programs
3. Slave mode
4. DMX addressing
5. Sound-controlled mode
6. Dimmer options
7. Settings
8. Info
Program speed, from 001-100
Strobe frequency, from 00-99
.
14
.
.
, press the SETUP button to
.
Advertisement
Table of Contents
Need help?
Do you have a question about the Data Flash Strobe and is the answer not in the manual?
Questions and answers