Table of Contents
Advertisement
Appendix 3
VERTICAL
Trace selection
VOLT/DIV
Zoom
Coupling
Offset
Offset setting
Probe ratio
Band Width
TRIGGER
Sweep Mode
Trig Type
Source
Coupling
Slope
Level
Holdoff
HORIZONTAL
TIME/DIV
Delay
ACQUISITION
Mode
Equ Smpl
Roll
Persist
Length
DISPLAY
Join
Type
Math
Others
REF waveform
AUTOSET measuring conditions
CH1 to CH4: Do not change the setting.
When frequency is 50 Hz to 50 MHz
2 mV to 10 V/div and amplitude approx. 2 to 7 div
Off
DC or AC
1 CH is displayed.:
2 CHs are displayed.: Near +2 div and –2 div from
3 CHs are displayed.: Near +3 div, +1 div, -1 div, and
4 CHs are displayed.: Near +3 div, +1 div, -1 div, and
Division
Auto
Off
Auto
Edge
Keeps the settings before execution. However, when
the channel of the trigger source is off, the On channel
is detected from the smallest channel No.
DC
Pos
Near center of waveform
Off
10 ms to 5 ns/div
Approx. 2.5 to 5 periods of signal
0.00
Norm Smpl
Depends on TIME/DIV setting.
Do not change the setting.
Off
Do not change the setting.
Do not change the setting.
YT
This setting is set to off for Add/Sub/Multi. YT is
displayed with the setting kept for FFT.
Do not change the setting.
Near 0 div from center of
screen.
center of screen.
-3 div from center of screen.
-3 div from center of screen.
79
Advertisement
Table of Contents
