Table of Contents
Advertisement
30
DISPLAY menu
DISPLAY Displays the DISPLAY menu related to the waveform or readout display.
(See Section 2 for details.)
Sets the contrast between the waveform and background. (0 to 100%)
Contrast
The contrast is automatically set initially when the power is turned on.
setting
You may adjust the contrast manually if necessary.
This manually-adjusted condition is maintained until the power is turned
off.
Join
Sets joining of dots ON or OFF.
Off: Displays the waveform as dots. All data in the display area is always
setting
On: Joins the dots of waveform data. Useful for observing a pulse
Interpolation data exists (Join = On)
Restrictions on join display
While waveform acquisition is under Run in long memory, waveforms are
displayed as joined dots.
If persistence is set to ON, the waveform is always displayed as dots.
Allows selection of waveform display format, YT, XY1&2, XY3&4, or
Display
TYPE setting
XY1&2/XY3&4.
YT display
Voltage axis Y
Time
axis T
displayed.
waveform or enlarged waveform. Peak compression is automatically
performed according to the display data count.
Displays
waveform by
expressing
vertical
direction on
the voltage axis
and horizontal
direction on
the time axis.
No acquired data in this interval
(Join = OFF)
XY1&2 display
Voltage axis Y (CH2)
Voltage
(CH1)
axis X
Displays waveform by
expressing the
horizontal direction on
the CH1 voltage axis
and the vertical
direction on the CH2
voltage axis.
This is used to show
phase relationship
between CH1 and
CH2.
Advertisement
Table of Contents
