Loading Printer Roll Paper - Iwatsu DS-8814 Operation Manual

Built-in printer
Attachment procedure
Open
the
Slide
cover
Paper holding lever
Paper holding
lever
Slide
Paper feed
Pressing the Copy button for 1 second or more starts paper
feed when the built-in printer is used. The paper feed stops
when the button is released.
(Pressing this button for less than 1 sec simply performs
normal copy operation.)

Loading printer roll paper

Turn on the power of the scope.
Pull up the handle. Unlock the slide button on the
Handle
printer cover toward the rear.
Open the cover.
Be sure to raise the handle before opening
the cover.
Cut the roll paper end straight, and pull out the
paper end by about 10cm.
Put the paper on the cover between the paper
guides. Set the holding lever to the center position
(lease) from the rear side position (lock).
Insert the paper end beneath the roller until the
paper is fed about 15 seconds automatically.
Move the paper from the cover to the paper holder.
Rewind the roll paper slightly to straighten the
paper. Set the paper holding lever toward the rear
to lock it.
Printing is not possible if the paper holding
lever is set to the Release position at the
center.
Insert the paper end into the hole of the cover, and
then close the cover.
Lock the slide button on the printer cover toward
the front (lock).
Attention
Attention
25