Run/Stop - Iwatsu DS-8814 Operation Manual

RUN/STOP Sets start/stop of waveform capturing.
Toggles between Run/Stop and displays the current condition at the
top center of the screen.
Operation Stops capturing a new waveform in the STOP condition. The already
while STOP
captured waveform (currently displayed waveform) can be enlarged
or reduced or its position can be varied for both the vertical and
horizontal axes. The following describes the operations when
performing various functions.
VOLTS/DIV
Can be set to any range.
OFFSET
Can be set to any range.
TIME/DIV Can be set to any range. However, there are some limitations of the
expansion setting as follows.
When memory length is Short: Max. 6 ranges expansion
When memory length is Long: Max. 12 ranges expansion
The reduction setting is limited to a maximum of 7 ranges irrespective
of memory length.
DELAY
Can be set to any range.
It is limited up to the screen center at both the top and tail of the
waveform.
The waveform is shifted
rightward by the Delay
operation.
RUN
Starts the waveform capturing. Pressing RUN again while Run mode
stops the waveform capturing and captures a new waveform under
new conditions.
Screen center
The waveform is shifted
lefttward by the Delay
operation.
21