Save/Recall/Delete - Iwatsu DS-8814 Operation Manual

70
Save/recall/delete (SAVE/RECALL/DELETE)
Also see Section 1 "SAVE/RECALL menu" (pages 36 to 39).
Capacity
Selecting DEVICE in the SAVE/RECALL menu shows the remaining
display
capacity of a medium.
Saving panel setting to ATA card
1. Display SAVE/RECALL menu.
2. Through [FUNCTION operation], set Device to ATA card.
3. Through [FUNCTION operation], set Type to Setup (panel
4. Set Function to Save with [Function operation].
5. Specify the File No. (e.g. specify "1").
6. After specifying the File No., press the FUNCTION knob. The
Recalling panel setting from ATA card
1 to 3. Perform the same setting as that for saving.
4. Through [FUNCTION operation], set Function to Recall (recall).
5. Specify the File No. (e.g. specify "1"). Only existing file Nos. are
6. Pressing the FUNCTION knob stops the recall.
While Floppy or ATA Card is highlighted, the remaining
capacity of the medium is displayed at the bottom of
the screen.
setting).
You can set the file No. in steps of 20 when Course is set.
message "Press FUNCTION to save" appears. Press the knob
again to execute SAVE. If the specified file already exists, the
message "Press FUNCTION again to overwrite" appears.
selected and displayed during a recall. If Coarse is selected, the
existing files are selected and displayed at every 20 steps. If no
files are found, **** is displayed. When recalling the panel setting
from an ATA card, selected file Nos. are recalled sequentially.