HP APOLLO 2000 User Manual page 153

Procedure
1. Power down the node.
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis.
4. Place the node on a flat, level surface.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To avoid damage to the processor and system board, only authorized personnel should attempt to
replace or install the processor in this node.
CAUTION:
To prevent possible node malfunction and damage to the equipment, multiprocessor configurations
must contain processors with the same part number.
CAUTION:
The heatsink thermal interface media is not reusable and must be replaced if the heatsink is
removed from the processor after it has been installed.
IMPORTANT:
Processor socket 1 must be populated at all times or the node does not function.
5. If installed in a 2U node, remove the FlexibleLOM 2U node riser cage assembly.
6. If installed in a 2U node, remove the three-slot riser cage assembly.
7. Remove the air baffle.
8. Open each of the processor locking levers in the order indicated in the following illustration, and then
open the processor retaining bracket.
9. Remove the clear processor socket cover. Retain the processor socket cover for future use.
Hardware options installation 153