The Slicer Will Not Start (Motor Is Humming); The Slicer Stops Before Slicing Is Complete; The Slicer Does Not Automatically Stop Upon Completion Of Slicing - Oliver 732-N User's Operating And Instruction Manual

Trouble Shooting (Continued)

The Slicer Will Not Start (Motor Is Humming)

A SPECIAL NON-VENTILATED MOTOR MUST BE USED WITH THIS SLICER.
•
The drive system is binding. (Have a qualified service agent check for defective
bearings or other restrictions to free movement.)
•
There is mechanical interference between other parts of the slicer. (Have a qualified
service agent evaluate the machine for adjustment or replacement of defective
parts.)
•
The motor has failed. (Have it checked by a qualified electrician.)

The Slicer Stops Before Slicing is Complete

•
The upper limit switch is not adjusted properly. (Have a qualified service agent
adjust the switch.)

The Slicer Does Not Automatically Stop Upon Completion of Slicing

•
The upper limit switch is not adjusted properly. (Have a qualified service agent
adjust the switch.)
•
The upper limit switch is defective. (Have a qualified electrician check and replace
the switch if required.)
•
A bread crust or other foreign object is preventing the cradle from returning to the top
of its travel.
0732S20006
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
DO NOT ALLOW THE MOTOR TO HUM WITHOUT STARTING.
OVERHEATING CAN PERMANENTLY DAMAGE THE MOTOR.
732-N Front Load Slicer
CAUTION
NOTE
Continued
5-2