Replacing The Gas Spring - Oliver 732-N User's Operating And Instruction Manual

732-N Front Load Slicer

Replacing The Gas Spring

WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
The Gas Spring is located on the right hand side of the machine, therefore the right hand
cover must be removed. Do this by first removing the hand lever by removing its set
screw located in the hub. See the illustration below.
Remove the bagging scoop, the top and front guards by removing the ten knobs which
secure them in place, also remove the crumb tray. Remove the handle by loosening the
set screw which holds the handle after which it can be slid out of the hub. The cover can
then be removed by first removing the six slotted head screws which secure it in place.
See the above illustration to see their approximate locations.
Continued
0732S20007 6-9
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor