Troubleshooting; The Slicer Will Not Start (Motor Is Not Humming); The Slicer Will Not Start (Motor Is Humming) - Oliver 797-48 User's Operating And Instruction Manual

ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK, INCLUDING

The Slicer Will Not Start (Motor Is Not Humming)

•
The machine is not plugged in.
•
There is no power at the outlet. (Check by plugging in a small working appliance,
like a lamp. Check to see if a circuit breaker has tripped. If the circuit breaker has
not tripped and the circuit is still not working have a qualified electrician check the
circuit.)
•
The motor switch overload has tripped. (To reset push firmly in the direction shown
on the switch nameplate.)
•
There are breadcrumbs in the motor starting switch. (Have a qualified electrician
disassemble the switch and clean it.)
•
The problem is somewhere in the electrical system of the machine. (Have a qualified
electrician find and repair the problem.)

The Slicer Will Not Start (Motor Is Humming)

DO NOT ALLOW THE MOTOR TO HUM WITHOUT STARTING.
OVERHEATING CAN PERMANENTLY DAMAGE THE MOTOR.
•
The motor has failed. (Have it checked by a qualified electrician.)
A SPECIAL NON-VENTILATED MOTOR MUST BE USED WITH THIS SLICER.
•
The drive system is binding. (Have a qualified service agent check for defective
bearings or other restrictions to free movement.)
•
There is mechanical interference between other parts of the slicer. (Have a qualified
service agent evaluate the machine for adjustment or replacement of defective
parts.)
0797S20068

TROUBLESHOOTING

WARNING
TROUBLESHOOTING.
CAUTION
NOTE
5-1