CalAmp Viper 100 User Manual page 93

4.8.1.2.2 ROUTE TO NEIGHBORING VIPER
― Hop Count/Next Hop. Indicates the route the remote Viper SC can be reached - when Hop Count is 1, the device can be
reached directly. When HOP COUNT is more than 1, it can be reached by passing though another Viper SC as identified
by the Next Hop field.
Entry Type
― Static. This entry has been defined by the user. The entry type can only be removed by the user. This entry cannot be
replaced by a "Dynamic" or "Locked" entry. "Static" neighbor entries can be added in any neighbor discovery mode. If
the user presses the "Save" button from the web page, all "Static" neighbor entries are saved in nvram. They are
recovered after a reboot.
― Dynamic. A "Dynamic" neighbor entry is one that has been learned by the neighbor discovery algorithm. It can be
updated or deleted by the neighbor Discovery algorithm when it detects changes in the topology.
― Locked. A "Locked" neighbor entry is a "Dynamic" neighbor entry saved into nvram. The "Locked" neighbor entry
behaves like a "Dynamic" neighbor except it is saved into nvram and will be recovered after a reboot.
4.8.1.3 CONTROL OPERATIONS
― Clear List. Select to clear the entries in the list and routing tables. If Auto-Scan is enabled, the neighbor list will be
repopulated automatically. If Manual-Scan is enabled, the neighbor list can be repopulated by clicking the Force Scan
button.
― Force Scan starts the Scanning for Neighbors process.
― Test Connectivity pings each Viper in the list to ensure an RF path between the units.
― Add Static Entry. Click to open a popup window where the user can add a new static neighbor entry. To create the new
neighbor, completely fill in all the information. The requested fields are described below. Finally, the user must press
Apply and Save Config for the new entry to be added to the network Routing Table. When a Static Neighbor entry is
created, all IP routes to that neighbor are created.
― Delete Entry.
001-5008-000_Rev12e.docx |
#9 Viper_SC_Manual_ Page 86