Appendix A - Specifications - CalAmp Viper 100 User Manual

APPENDIX A – SPECIFICATIONS
These specifications are typical and subject to change without notice.
GENERAL
Model Numbers, Frequency
Range and Bandwidth
Frequency Stability
Modes of Operation
Frequency Increment
Power Source
RF Impedance
Operating Temperature
Storage Temperature
Operating Humidity
Rx Current Drain at 25°C
Tx Current Drain at 25°C
Cold start
Nominal Dimensions
Shipping Weight
Mounting Options
Fan Output
Model Numbers Frequency Range
140-5018-502
140-5018-600
140-5028-502
140-5028-504
140-5048-302 406.125 – 470.000 MHz,
140-5048-400 406.125 – 470.000 MHz,
140-5048-502 450.000 - 511.975 MHz
140-5048-600 450.000 - 511.975 MHz
140-5098-304
140-5098-502
140-5098-504
The Viper is UL approved when powered with a listed Class 2 power supply.
-40° to + 85° C, 95% non-condensing RH
Power Out
Max Pwr
30 dBm (1W)
5.50" W x 2.125" H x 4.25" D (13.97 x 5.40 x 10.8 cm)
136 – 174 MHz
136 – 174 MHz
215 – 240 MHz
215 – 240 MHz
880 – 902 MHz
928 – 960 MHz
928 – 960 MHz
1.0 ppm
Simplex, Half-Duplex
1.25 kHz
VDC, Negative GND
50 Ω
-30° to + 60° C
5% to 95% non-condensing RH
DC Input 10V
520 mA (max)
450 mA (typ)
DC Input 10V
5.8 A (max)
3.6 A (typ)
1.6 A (max)
1.2 A (typ)
35 seconds
2.4 lbs. (1.1 Kg)
Mounting plate/pattern & DIN Rail
5VDC, 400mA max.
Channel Bandwidths Available
6.25 kHz, 12.5 kHz, 25 kHz, 50 kHz
6.25 kHz, 12.5 kHz, 25 kHz, 50 kHz
6.25 kHz, 12.5 kHz, 25 kHz, 50 kHz
6.25 kHz, 12.5 kHz, 25 kHz, 50 kHz,
100kHz
6.25 kHz, 12.5 kHz, 25 kHz, 50 kHz
12.5kHz, 25kHz (ETSI, AS/NZ)
6.25 kHz, 12.5 kHz, 25 kHz, 50 kHz
12.5kHz, 25kHz (ETSI, AS/NZ)
12.5 kHz, 25 kHz, 50 kHz, 100 kHz
12.5 kHz, 25 kHz, 50 kHz
12.5 kHz, 25 kHz, 50 kHz, 100 kHz
DC Input 20V DC Input 30V
270 mA (max) 190 mA (max)
240 mA (typ) 170 mA (typ)
DC Input 20V DC Input 30V
2.5 A (max) 1.6 A (max)
1.8 A (typ) 1.2 A (typ)
0.8 A (max) 0.6 A (max)
0.6 A (typ) 0.4 A (typ)