Front Panel - CalAmp Viper 100 User Manual

LED Color
ACT Blinking Green
Off
Lnk Green
Off
Rx/Tx Green
Red

1.3.3 FRONT PANEL

Shown in Figure 2, the front panel has the following connections:

(1) RJ-45 LAN 10 BaseT Ethernet connection with Auto-MDIX

(1) 50-ohm TNC female Antenna connector

(1) 50-ohm SMA female receive antenna connector (Dual-Port models only)

(1) Right-angle power connector (10-30 VDC)

(2) DE-9F RS-232 ports
Figure 2 – Front Panel (Dual Port Viper-200 Shown)
1.3.3.1 ETHERNET LAN PORT
The Ethernet LAN port is an RJ-45 receptacle with a 10 BaseT Ethernet connection and Auto-MDIX. Refer Table 2 for pin out
descriptions and Section 4.6.1 to configure the LAN settings for this port.
Table 2 – Pin-out for IEEE-802.3 RJ-45 Receptacle Contacts
Contact
1
2
3
4
5
Definition
Ethernet activity detected on PHY link (RJ45)
No Ethernet activity on PHY link (RJ45)
Ethernet connection established (RJ45)
No Ethernet connection (RJ45)
Receiving data
Transmitting data
10 Base-T Signal
TXP(1)
TXN(1)
RXP(1)
SPARE
SPARE
001-5008-000_Rev12e.docx |
#9 Viper_SC_Manual_ Page 3