Configure An A-240Z-A Cpe; General; Gui Configuration; Login - Nokia 7368 ISAM CPE A-240Z-A Product Manual

Table of Contents

7368 ISAM CPE A-240Z-A Product Guide

8 Configure an A-240Z-A CPE

Please refer to the configuration information provided with your OLT for the software

configuration procedure for an A-240Z-A CPE.

For HTTP configuration procedures, please refer to the 7368 ISAM CPE

Configuration, Management, and Troubleshooting Guide.

Use the procedures below to use the web-based GUI for the A-240Z-A.

The A-240Z-A is used as an Ethernet gateway to connect devices in the home to the

Internet. The GUI provides a variety of features for the home network including

routing and firewall capability. By using the GUI, users can connect all smart

equipment in their home, including personal computers, set-top boxes, mobile

phones, and other consumer electronics devices, to the Internet.

8.2.1

Use the procedure below to login to the web-based GUI for the A-240Z-A.

Procedure 6

Issue: 01

All manuals and user guides at all-guides.com

8.1 General

8.2 GUI configuration

8.3 IOT application software package download

Open a web browser and enter the IP address of the CPE in the address bar.

The login window appears.

The default gateway IP address is http://192.168.1.1. You can connect to this IP address

using your web browser after connecting your PC to one of Ethernet ports of the CPE. The

static IP address of your PC must be in the same 192.168.1.x subnet as the CPE.

Enter your username and password in the Log in window, as shown in Figure 15.

3FE-46615-AAAA-TCZZA

Configure an A-240Z-A CPE

Table of Contents