Resetting The Emg6765-Q10A To Its Factory Defaults; Wireless Connections - ZyXEL Communications EMG6765-Q10A User Manual

26.5 Resetting the EMG6765-Q10A to Its Factory Defaults

If you reset the EMG6765-Q10A, you lose all of the changes you have made. The EMG6765-Q10A re-
loads its default settings, and the password resets to the back-label default key. You have to make all of
your changes again.
You will lose all of your changes when you push the RESET button.
To reset the EMG6765-Q10A:
Make sure the power LED is on.
1
Press the RESET button for one to four seconds to restart/reboot the EMG6765-Q10A.
2
Press the RESET button for more than five seconds to set the EMG6765-Q10A back to its factory-default
3
configurations.
If the EMG6765-Q10A restarts automatically, wait for the EMG6765-Q10A to finish restarting, and log in to
the Web Configurator. The password is in the back label of your EMG6765-Q10A.
If the EMG6765-Q10A does not restart automatically, disconnect and reconnect the EMG6765-Q10A's
power. Then, follow the directions above again.

26.6 Wireless Connections

I cannot access the EMG6765-Q10A or ping any computer from the WLAN.
Make sure the wireless LAN is enabled on the EMG6765-Q10A.
1
Make sure the wireless adapter on your computer is working properly.
2
Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports the
3
same wireless standard as the EMG6765-Q10A.
Make sure your computer (with a wireless adapter installed) is within the transmission range of the
4
EMG6765-Q10A.
Check that both the EMG6765-Q10A and the wireless adapter on your computer are using the same
5
wireless and wireless security settings.
Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the EMG6765-Q10A.
6
Make sure you allow the EMG6765-Q10A to be remotely accessed through the WLAN interface. Check
7
your remote management settings.
Chapter 26 Troubleshooting
EMG6765-Q10A User's Guide
188