Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 51 Network > Static Route: Add/Edit
LABEL
DESCRIPTION
Static Route
Select to enable or disable this rule.
Route Name
Type a name to identify this rule. You can use up to 31 printable English keyboard characters,
including spaces.
Destination IP
This parameter specifies the IP network address of the final destination. Routing is always
Address
based on network number. If you need to specify a route to a single host, use a subnet mask
of 255.255.255.255 in the subnet mask field to force the network number to be identical to the
host ID.
IP Subnet Mask
Enter the IP subnet mask here.
Use Gateway IP
Select to enable or disable this rule.
Address
Gateway IP
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the same
Address
segment as your EMG6765-Q10A's interface(s). The gateway helps forward packets to their
destinations.
Use Interface
Select a WAN interface through which the traffic is sent. You must have the WAN interface(s)
already configured in the WAN screens.
Back
Click Back to return to the previous screen without saving.
Apply
Click Apply to save your changes back to the EMG6765-Q10A.
Cancel
Click Cancel to set every field in this screen to its last-saved value.
Chapter 15 Static Route
EMG6765-Q10A User's Guide
123
Advertisement
Table of Contents
