Front Panel - ZyXEL Communications EMG6765-Q10A User Manual

Press the WPS button for more than one second and release it. Press the WPS button on another WPS-
2
enabled device within range of the EMG6765-Q10A.
Note: You must activate WPS on the EMG6765-Q10A and on another wireless device within
two minutes of each other.
For more information on using WPS, see

1.6 Front Panel

The LED indicators are located on the front panel. Look at the LED lights on the front panel to determine
the status of the EMG6765-Q10A. Front Panel
Power
Internet
The following table describes the LEDs.
Table 1 Front Panel and Rear panel LEDs
LED
Power
Internet
WLAN 2.4/5G
(White)
WLAN 2.4/5G
(Amber)
Chapter 1 Introduction
WLAN 2.4G
MoCA
WLAN 5G
STATUS DESCRIPTION
On The EMG6765-Q10A is receiving power and functioning properly.
Off The EMG6765-Q10A is not receiving power.
On The EMG6765-Q10A has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP server),
PPP negotiation was successfully completed (if used) and the connection is up.
Blinking The EMG6765-Q10A is sending or receiving IP traffic.
Off The EMG6765-Q10A does not have an IP connection.
On The EMG6765-Q10A is ready, but is not sending/receiving data through the 5G
wireless LAN.
Blinking The EMG6765-Q10A is sending/receiving data through the 5G wireless LAN.
The EMG6765-Q10A is negotiating a WPS connection with a wireless client.
Off The wireless LAN is not ready or has failed.
On The EMG6765-Q10A is setting up a WPS connection with a 2.4GHz or 5GHz
wireless client.
Off The 2.4 GHz or 5GHz WPS process is completed or failed.
EMG6765-Q10A User's Guide
Section 6.8 on page
15
48.