ZyXEL Communications EMG6765-Q10A User Manual page 27

Table 7 Navigation Panel: Router Mode (Admin) (continued)
LINK TAB
Wireless LAN General
2.4G/5G
More AP
MAC Filter
Advanced
QoS
WPS
WPS Station
Scheduling
LAN IP
IP Alias
IPv6 LAN
IGMP
Snooping
MoCA MoCA
Monitor
DHCP Server General
Advanced
Client List
NAT General
Port
Forwarding
Port Trigger
Dynamic DNS Dynamic DNS
Static Route Static Route
Interface Interface
Group
Group
Security
Firewall General
Services
Content Filter Content Filter
IPv6 firewall Services
Parental Parental
Control
Control
Management
Chapter 4 Router Mode
FUNCTION
Use this screen to enable the wireless LAN and configure wireless LAN and
wireless security settings.
Use this screen to configure multiple BSSs on the EMG6765-Q10A.
Use the MAC filter screen to configure the EMG6765-Q10A to block access to
devices or block the devices from accessing the EMG6765-Q10A.
This screen allows you to configure advanced wireless settings.
Use this screen to configure Wi-Fi Multimedia Quality of Service (WMM QoS).
WMM QoS allows you to prioritize wireless traffic according to the delivery
requirements of individual services.
Use this screen to configure WPS.
Use this screen to add a wireless station using WPS.
Use this screen to schedule the times the Wireless LAN is enabled.
Use this screen to configure LAN IP address and subnet mask.
Use this screen to have the EMG6765-Q10A apply IP alias to create LAN
subnets.
Use this screen to configure the IPv6 address for the EMG6765-Q10A on the
LAN.
Use this screen to activate IGMP snooping and configure IGMP modes.
Use this screen to set the MoCA Privacy, and enable multimedia and home
networking over coaxial cabling.
Use this screen to view the MoCA connection status and information about the
connected MoCA device(s).
Use this screen to enable the EMG6765-Q10A's DHCP server.
Use this screen to assign IP addresses to specific individual computers based
on their MAC addresses and to have DNS servers assigned by the DHCP server.
Use this screen to view information related to your DHCP status.
Use this screen to enable NAT.
Use this screen to configure servers behind the EMG6765-Q10A and forward
incoming service requests to the server(s) on your local network.
Use this screen to change your EMG6765-Q10A's port triggering settings.
Use this screen to set up dynamic DNS.
Use this screen to configure IP static routes.
Use this screen to add a LAN interface or a VLAN ID to a new group.
Use this screen to activate/deactivate the firewall.
This screen shows a summary of the firewall rules, and allows you to edit/add a
firewall rule.
Use this screen to restrict web features and designate a trusted computer.
Use this screen to configure IPv6 firewall rules.
Use this screen to block certain web features and sites containing certain
keywords in the URL.
EMG6765-Q10A User's Guide
27