Operation; Overview; Source Selection; Manual Source Selection - ATEN VS0801A User Manual

8-port vga switch with auto switching

Hide thumbs Also See for VS0801A:

Table of Contents

The VS0801A 8-Port VGA Switch with Audio offers easy operational control

via Front Panel Pushbuttons, Remote Control, Port Switching VGA Cable, or

RS-232 Serial Control. All operational functions are discussed in this chapter

including; Source Selection, Pushbutton Lock, Auto Switch, RS-232 serial

configuration and commands, and Power Off/Restarting.

To manually select a source device, press the front panel pushbutton (1~8) that

corresponds to the port that it is connected to. The port LED lights green to

indicate which port is currently selected for use.

To select a source device with the remote control, press the number button on

the remote that corresponds to the port it is connected to.

Alternatively, you can cycle through the source devices by pushing the Port Up

and Port Down buttons on the remote control.

 Use the Port Up button to select the next port in ascending order (from left

to right on the front panel display)

 Use the Port Down button to select the next port in descending order (from

right to left on the front panel display)

Note: For optimum performance, make sure there is a clear line-of-sight

between the remote control and IR receiver, and aim the remote control directly

at the IR receiver located on the front panel.

Chapter 3

Operation

Table of Contents