Rs-232 Serial Interface; Configuring The Serial Port; Verification - ATEN VS0801A User Manual

8-port vga switch with auto switching

Hide thumbs Also See for VS0801A:

Table of Contents

RS-232 Serial Interface

The VS0801A's built-in bi-directional RS-232 serial interface allows system

control through a high-end controller, PC, and/or home automation / home

theater software package.

The controller's serial port should be configured as follows:

RS-232 control commands for Switch Port, Auto Switch, Power on Detection,

Dynamic DDC, Pushbutton Lock, Cable Button, Read Firmware and Reset are

discussed on the pages that follow.

In the steps below, after entering a command, a verification message appears

at the end of the command line as follows:

 Command OK - indicates that the command is correct and successfully

performed by the switch.

 Command incorrect - indicates that the command has the wrong format

and/or values.

Baud Rate

19200

Data Bits

Parity

None

Stop Bits

Flow Control

None

Chapter 3. Operation

Table of Contents