Chapter 3. Operation
IR Code
If you purchased a new IR remote control with the need to control multiple
switches separately, you need to change the IR code of the switch to match that
of the new remote. Try all three codes until the new IR remote control works
with the switch.
To change the IR code on the switch, press and hold the port selection
pushbuttons for 3 seconds:
Pushbutton 1 & 2: IR Code: 00FF (default)
Pushbuttons 1 & 3: IR Code 00FD
Pushbutton 1 & 4: IR Code 8A75
VGA Cable Source Selection
An optional Port Switching VGA Cable can be purchased separately which
provides a high quality VGA connection that allows you to use a port switching
button to switch the VS0801A to the connected device. This optional accessory
is installed between the VS0801A and a source device (See Installation
Diagram, page 14, for details). Simply press the port switching button located
on the VGA cable to switch the VS0801A to that device.
Port Switching VGA Cable
Port Switching Button
To purchase Port Switching VGA Cables, please contact your local ATEN
dealer.
16