Alarm - EverFocus EPRO NVR Series User Manual

EPRO NVR Series
Post Recording: Select a post recording time when motion events occur.
Latch Time: Select a latch time (duration) when motion events occur. When a motion object
is detected, the alarm will last based on the latch time.
Alarm Out: Check the box to enable the alarm output.
Show Message: Check the box to enable the function. When an event occurs, an event
message will be displayed on the live screen.
Send Email: Check the box to enable the function. When an event occurs, the NVR will send
an email alert to the receiver. Note that for this function to work, you have to set up the
Email function in advance (refer to 4.1.1.3.2 Email).
Full Screen: Check the box to enable the function. When an event occurs, the corresponding
channel with the event will be switched to full screen on the live screen.
Record Channel: Check the box to enable the function. When an event occurs, the selected
channel(s) will be recorded.
Click Save to save the settings, or Cancel to cancel and leave the page.

4.1.1.4.2 Alarm

You can configure the Alarm setting on this page.
Alarm In: Select an alarm input from the drop-down list.
Alarm Type: Select an alarm type. N.O or N.C. If you want to disable the alarm, select Off.
Latch Time: Set up the time for buzzer to sound when an alarm is triggered by external
sensor.
50