Table of Contents
Advertisement
Daylight Saving Time: Check the box to enable the DST function.
Daylight Saving Time Mode: Select Week or Date to configure the start/end time below.
Time Offset: Select an offset time.
Start Time: Select a start time for the DST to start.
End Time: Select an end time for the DST to stop.
NTP: Select to configure the NTP function.
Enable NTP: Check the box to enable the NTP function.. When NTP function is enabled,
the system will calibrate the system time at 00:07:50 daily and every time when the
system is started up.
Server Address: Select a NTP server.
Time Zone: Select a time zone.
Click Save to save the settings or Refresh to refresh the page.
106
EPRO NVR Series
Advertisement
Table of Contents
