Password: Input the password of the sender. Note that this column cannot be blank.
Sender: Input the Email address of the sender. Note that the email format should be
xxx@xxx.xxx.xxx
Receiver1: Input the Email address of the receiver. Note that the email format should be
xxx@xxx.xxx.xxx
Interval: Configure an interval to send Emails when events occur.
b. On the Motion or Alarm page, configure the desired settings and then enable Send Email.
Click Save to save the settings.
2. On the Genie XMS:
a. On the NVR device Maintain page, configure the related settings and then input the
Network ID. The Network ID is the IP address of the NVR.
122
EPRO NVR Series