Alarm; Motion - EverFocus EPRO NVR Series User Manual

EPRO NVR Series

5.4.4 Alarm

You can configure the motion and alarm settings on this page.

5.4.4.1 Motion

You can configure the Motion setting on this page.
Channel: Select a channel to apply with the motion detection function.
Enable: Check Enable to enable the function.
Sensitivity: Select a sensitivity value from the drop-down list. The larger the value, the
higher the sensitivity.
Buzzer: Select a buzzer sound duration from the drop-down list. If you want to disable the
buzzer, select Off from the drop-down list.
Full Screen: Check the box to enable the function. When a motion event occurs, the
corresponding channel with the motion event will be switched to full screen on the live
screen.
Alarm Out: Check the box to enable the alarm output.
Latch Time: Select a latch time (duration) when motion events occur. When a motion object
is detected, the alarm will last based on the latch time.
Enable Record: Check the box to enable the post recording function. You can further set up
the post recording time when motion events occur.
Post Recording: Select a post recording time when motion events occur.
Show Message: Check the box to enable the function. When a motion event occurs, a
motion event message will be displayed on the live screen.
Send Email: Check the box to enable the function. When a motion event occurs, the NVR will
send an email alert to the receiver. Note that for this function to work, you have to set up
the Email function in advance (refer to 5.4.4.2 Email).
98