Troubleshooting - Funkwerk EGO FLASH Operating Manual

Troubleshooting

Problem
EGO FLASH won't switch on
The person you are having a phone
conversation with cannot hear you
The person you are
having a phone conversation
with complains of interference
The person you are
having a phone conversation
with complains of echoes
The mobile phone cannot
fi nd the EGO FLASH during coupling
Sound is fuzzy or scratchy
After switching on
the ignition, the connection
to the coupled mobile phone
is not produced.
Cause
No supply voltage
Ignition not switched on
Ignition line interrupted
The microphone is not plugged in
Air is fl owing across the microphone
The mobile phone is very close to
parts of the EGO FLASH or the car radio
Too little space between
the microphone and speaker
Volume too high
EGO FLASH is already coupled with a device
Poor Bluetooth ® connection
The mobile phone is not within range.
The Bluetooth ® interface is
deactivated in the mobile phone.
The mobile phone requires
confi rmation of the connection setup.
One of the devices no longer has a valid link key.
Remedy
Replace fuse if needed and check cable and connections
Switch on ignition
Check line and 1A fuse
Connect the microphone to the electronics box. If the
cable is defective, replacement is necessary
Mount the microphone in another place or
reduce air fl ow if needed
Increase the distance between your mobile
phone and the EGO FLASH or radio
Increase distance or decrease volume
Reduce volume
Cancel existing connection
Reduce the distance between the mobile phone and
EGO FLASH or remove (metallic) obstructions if needed
Place the mobile phone within the range of the EGO FLASH
Switch your mobile phone's Bluetooth
to "On" ("Automatic" option is not suffi cient)
Confi rm the connection on the mobile phone. Deactivate the
security prompt (see operating instructions for the mobile phone)
Delete the other device from both devices'
list of coupled devices and perform a new coupling.
®
|
50 51