Advertisement

Handsfree System

Operating Manual

156 8010 1.01

Advertisement

Table of Contents
loading

Summary of Contents for Funkwerk AUDIO 2010

  • Page 1: Operating Manual

    Handsfree System Operating Manual 156 8010 1.01...
  • Page 2 Audio 2010 Funkwerk Dabendorf GmbH Maerkische Straße D - 15806 Dabendorf Phone: +49 3377 316 - 0 Fax: +49 3377 316 - 300 info@fwd-online.de www.fwd-online.de Rights to changes and deviations from the scope of delivery reserved as required by technical pro-...
  • Page 3: Table Of Contents

    Audio 2010 Table of contents Table of contents Notes on safety ................4 Functions of the Audio 2010 ............5 Functional overview ................5 Symbols .................... 6 Key functions ..................6 Symbole der Statusleiste ..............8 Speller symbols .................. 8 Menu item symbols ................
  • Page 4: Notes On Safety

    Audio 2010 Notes on safety Notes on safety IMPAIRMENT OF TRAFFIC SAFETY! Inattention can lead to dangerous traffic situations. Also in the handsfree mode, you must always pay attention to the traffic situa- tion. The telephone may be used by the driver during driving in...
  • Page 5: Functions Of The Audio 2010

    Audio 2010 Functions of the Audio 2010 Functions of the Audio 2010 Functional overview • Call functions ➯ Incoming call ➯ Outgoing call ➯ Automatic redialing • Status indicator ➯ Rechargeable battery status of the mobile telephone ➯ Network status indicator ➯...
  • Page 6: Symbols

    Symbols Symbols The actuator of the Audio 2010 is provided with an OLED display and a total of 8 keys. The display shows a short overview of the existing keys. The functions of the individual keys are explained in this section.
  • Page 7 Brief description: and Speller, termination of the screen saver ➔ The voice control of the Audio 2010 is activated by short pressing of the voice command key (buzzer). For possible speech commands, refer to Chapter „Voice control“ (see Page 24).
  • Page 8: Symbole Der Statusleiste

    Audio 2010 Symbols Symbols of the status bar Field strength symbol - Display of the current reception field strength of the mobile telephone SMS symbol - Display for received Arrow symbol - Display for call in absence Display of the initials of the user...
  • Page 9: Speller

    It is available for various functions of the Audio 2010, for example for the dialing of a telephone number or the gene- ration of a telephone directory entry. The operation of the Speller is explained below: ➔...
  • Page 10: Bluetooth ® Technology

    Switching on / Switching off With the first operational startup of your Audio 2010, you must start the Audio 2010 through switching on the ignition. You will see the start logo and the main screen is displayed.
  • Page 11: Handsfree Mode (Handsfree Profile)

    The mobile telephone then starts the device identification. In the list of the devices found by your mobile telephone, select „Audio 2010“. You are requested to enter a PIN or a password during the coupling procedure of your mobile telephone.
  • Page 12: Volume Control

    -key (red). Making a call ® Making a call from the Audio 2010 is possible only if a Bluetooth link exists bet- ween the Audio 2010 and the mobile telephone. You have the possibility to structure a call over the voice dial or over the menu.
  • Page 13: The Menus

    -key (green). The call is now possible over the mobile telephone only. A communication over the Audio 2010 is suppressed at this moment and the other vehicle occupants cannot overhear the call. A renewed pressing of the -key (green) ends the private mode.
  • Page 14 Player“ offers the possibility to control the iPod using the Audio 2010. Under „Options“, a search can be made in different title lists, as is well known from the iPod . You can find further information on this in Chapter „iPod...
  • Page 15 Audio 2010 Operational startup -15-...
  • Page 16: User Administration

    In order to reach user administration, go into the main menu on symbol press -key (green). You can then view the users who have made a coupling with the Audio 2010 and the point „New user“. If no users are coupled, select only the point „New user“. Creating new user In order to log on a new user, select the point „New user“...
  • Page 17 In this case, the possibility exists to log on a second user, as well as the active user. The active user can continue to use all functions of the Audio 2010 which the mobile telephone supports, where the second user is limited to the functions „Log on“/„Log off“/„Hang up“.
  • Page 18 You can select between „Connect manually“ and „Connect automatically“. Power off delay You can determine how long the Audio 2010 should remain active after shut- down of the ignition. The delayed switch-off time can be adjusted in steps of bet- ween 0 and 30 minutes.
  • Page 19 In the case of the Audio 2010, ten possible levels of sensitivity can be selected between. The sensitivity levels are repre- sented to the right in the display as bars.
  • Page 20 „iDapter“ has been acquired or when acces- sories have been retrofitted. The iPod Player can also be activated if no mobile telephone is coupled with the Audio 2010. In order to enable the playing of music by the iPod , an iPod must be connected on the iDapter cable.
  • Page 21 Audio 2010 from the music device over the menu item „Couple from the device“. In both cases, a four-digit PIN code is displayed by the Audio 2010, which must be entered in the music device. If the PIN is entered incorrectly, a return is made into the device selection and you can carry out the procedure again.
  • Page 22 In the menu item „Call list“, you can view the call lists „Dialed number“, „Mis- sed calls“ and „Accepted calls“. Some mobile telephones do not support access to the call lists. Then its own call list is maintained by the Audio 2010. Telephone directory...
  • Page 23 Under the point „Synchronizing“, it is possible to transmit the telephone direc- tories from the mobile telephone or from the SIM card to the memory of the Audio 2010. Both telephone directories can also be synchronized together. If a telephone directory is selected, this is confirmed with the -key (green).
  • Page 24: Voice Control

    Audio 2010. Voice control The interactive voice control of the Audio 2010 enables you to dial a name or number through voice data entry. While the number dialing enables you to speak a number directly, on the other hand you have the possibility to select names directly from the telephone directory.
  • Page 25: Activation And Sequence

    „Please speak …“. You can interrupt every speech dialog at almost any point through pressing the -key (red). If the Audio 2010 waits for a speech command, you can also end ® a dialog through speaking the command „Interrupt“. If no Bluetooth mobile telephone is connected with the Audio 2010, the voice dial cannot be activated.
  • Page 26 Audio 2010 Voice control Further speech commands / Voice data entry Explanation • „Yes / Call / Dial“ „Dial / Call <Name> at home / private / • „No / Back“ official business at work / in the office / •...
  • Page 27 The command can be called at all times, similar to „Interrupt“. If „Help“ is called, „Help“ the Audio 2010 explains , which commands are possible with which function at the time of the call. With the command the current dialog is (abort / cancel) “...
  • Page 28: Service

    1. Is it possible to carry out a direct dial (without voice control) on the Audio 2010? Under the menu item: „Telephone directory / Option / Direct dial“. 2. What are the precise dimensions of the Audio 2010 components? You can find the dimensions in the installation instructions under the point „Technical data“.
  • Page 29: Faq - Frequently Asked Questions

    Cause Solution As appropriate, replace Supply voltage not present fuse as well as test cables and connections Audio 2010 does not switch on Ignition not switched on Switch on ignition Ignition line interrupted Check line and 5A fuse Connect microphone plug...
  • Page 30 FAQ - Frequently Asked Questions Problem Cause Solution Bring the mobile The mobile telephone is telephone into range of not in range. the Audio 2010. ® Switch in Bluetooth ® The Bluetooth interface your mobile telephone in the mobile telephone is „ON“...
  • Page 31: Software Updating

    Audio 2010 Software updating Software updating The Audio 2010 can be updated with the latest software in each case. This soft- ® ware updating is possible over Bluetooth . In order to obtain the most current software, please visit our Internet site at www.fwd-online.de. A precise descrip- tion of the updating procedure is enclosed with the software.
  • Page 32 Adress: Märkische Straße D - 15806 Dabendorf Fon: +49 3377 316 - 0 Fax: +49 3377 316 - 300 Email: info@fwd-online.de Funkwerk Dabendorf GmbH Web: www.fwd-online.de...

Table of Contents