Add-On Speakers / Car Audio Telephone Connection; Car Audio Line-In; Installation Locations; Checking Cable Lengths - Funkwerk EGO FLASH Operating Manual

6.1.5 Add-on speakers / Car audio telephone connection

The car's loudspeakers are transferred to the system is by means of switch contacts. These are designed for a peak power
handling of 35 W (Sinus). Loudspeaker power handling exceeding 35 W leads to premature wear on the switching contacts.
For higher outputs, use the telephone connection of the car audio or a 5 W / 4-Ohm satellite speaker. This port is only
designed for voice reproduction.
6.1.6 Car audio line-in input
A car audio with a line-in input option is required for music reproduction in stereo. As an alternative to line-in, the car
audio may have a mini-ISO port (block connector C), a 0.14 in jack socket or a RCA input socket. An appropriate adapter
lead is required for the connection between the EGO FLASH line-out and the line-in version of your audio system. If your
car audio system has no line-in option, you can employ the optionally available Stereo Mute Box for stereo reproduction in
combination with your car's front speakers.
6.2

Installation locations

q
RISK OF INJURY! Unsuitable installation locations may become a source of injury in an accident (or emergency braking)
situation, or may inhibit the correct functioning of essential safety equipment.

6.2.1 Checking cable lengths

Before you've securely installed the components, check that
the installation locations have been selected in such a way
that the cable length is suffi cient to connect the individual
components.
6.2.2 Selection of the installation location for the
electronics box
®
The Bluetooth antenna for the connection to the mobile
phone is installed in the electronics box. The antenna
Fig. 02:
Signal transmission of
the Bluetooth ® antenna
|
10 11