Cabling The Exp100 To A Ds4000 Storage Subsystem; Lc-Lc Fibre Channel Cable Lever And Latches - IBM TotalStorage DS4000 EXP100 Installation, User's, And Maintenance Manual

Cabling the EXP100 to a DS4000 storage subsystem

|
|
|
|
|
|
|
|
|
Attention: To avoid damaging the LC-LC cable or SFP module, make sure that
you observe the following precautions:
v Press and hold the lever to release the latches before you remove the cable from
the SFP module.
v Ensure that the levers are in the released position when you remove the cable.
v Do not grasp the SFP module plastic tab when you remove the cable.
1. On the end of the LC-LC cable that connects into the SFP module or host bus
adapter, press down and hold the lever to release the latches, as shown in
Figure 35.
Lever
Figure 35. LC-LC Fibre Channel cable lever and latches
2. Carefully pull on the connector to remove the cable from the SFP module, as
shown in Figure 36.
Figure 36. Removing the LC-LC Fibre Channel cable
3. Replace the protective caps on the cable ends.
4. Replace the protective cap on the SFP module.
You can cable the EXP100 to any one of the following storage subsystems:
v DS4100
v DS4300
v DS4400
v DS4500
v DS4800
To cable the expansion enclosure to any DS4000 storage subsystem, you need
optional LC-LC fiber-optic cables.
Latches
Chapter 2. Installing the EXP100
53