Table of Contents
Advertisement
2.10 Selection of Copper RJ-45 or Fiber SFP
The Ethernet port of the device supports either copper RJ-45 connection over Cat.5 or SFP over fiber cable.
The selection of RJ-45 or SFP can be configured through web and console configuration. Three configuration
options are:
AUTO
Factory default setting
SFP is selected if SFP has transceiver installed
RJ-45 is selected if SFP has no transceiver installed
RJ-45
RJ-45 is selected always.
SFP
SFP is selected always.
Change of this configuration will be effective in next boot-up.
2.11 Setting DIP Switches
KSC-361-S2 (RS-232 model)
SW
Name
Setting
1
CM
ON
OFF
2
RSD
KSC-361-S4 (RS-422/485 model)
SW
Name
Setting
1
CM
ON
OFF
2
2W-4W
ON
OFF
3
2W-4W
ON
OFF
4
RTM
ON
OFF
5
TXE
ON
OFF
6
RXE
ON
OFF
Serial port serves console configuration.
Serial port serves standard functions.
-
Reserved
Serial port serves console configuration.
Serial port serves standard functions.
2-wire bus,( TX+(B) connects RX+(B) internally )
4-wire bus
2-wire bus,( TX-(A) connects RX-(A) internally )
4-wire bus
Receiver terminator is ON.
Receiver terminator is OFF.
Transmitter is enabled always. (serving as the
master node in a multi-drop network)
Transmitter is controlled by ADC.
Receiver is enabled always. (serving as a slave
node in a multi-drop network)
Receiver is controlled by ADC.
Function
Function
-27-
Advertisement
Table of Contents
